![]() usr/sbin/mysqld(my_print_stacktrace(unsigned char const*, unsigned long)+0x44) Stack_bottom = ffff9fd7e690 thread_stack 0x46000 If you see no messages after this, something went You can use the following information to find out Most likely, you have hit a bug, but this error can also be caused by malfunctioning hardware.Īttempting backtrace. InnoDB: corruption in the InnoDB tablespace. InnoDB: immediately after the mysqld startup, there may be InnoDB: If you get repeated assertion failures or crashes, even InnoDB: We intentionally generate a memory trap. T12:38:03.059589Z 1 InnoDB initialization has started. Process: 3285 ExecStartPre=/usr/share/mysql/mysql-systemd-start pre (code=exited, status=0/SUCCESS) Loaded: loaded (/lib/systemd/system/rvice enabled vendor preset: enabled)Īctive: failed (Result: exit-code) since Tue 18:08:10 IST 1min 16s ago However, when I updated the data directory from /etc/mysql//mysqld.cnf file, the issue crept up again.ĭoes this tell me that there could be an issue on the the data directory ? Any solution to recover from this scenario ? Execution Result: systemctl status rvice rvice - MySQL Community Server.Tried to start the MySQL service using the above command, the service started without any issues.See "systemctl status rvice" and "journalctl -xe" for details. ![]() I was running MySQL v8 on one of my Raspberry Pi 4 (8 GB) for a few months, however the I am unable to start mysql using sudo service mysql start since morning and receiving below error message: Job for rvice failed because the control process exited with error code.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |